CAMERA LIGHT DL150
1. Universal cradle head: universal metal cradle head is used to adjust the irradiation direction of LED lights.
2. Hot boots: Used for connecting and fixing LED lights and camera equipment.
3. Panasonic battery adapter: it is specially used for the connection and installation of Panasonic lithium battery.
4. Switch and dimmer knob: It is used for switch control and non-pole adjustment of LED light brightness. Users can adjust the brightness according to their own needs in different shooting environments.
5. Battery cover: Fix the battery.
6. Soft light and yellow light: it is equipped with soft light and yellow light. No soft light or yellow light is used. Add soft film, the light effect is soft light, when using yellow film, the color temperature of the light changes from 5400K to 3200K.
7.126t /150T is equipped with a splicing plug. The LED lamp is surrounded by a hot boot. The splicing plug can realize the combined splicing of multiple camera lamps horizontally, vertically and horizontally.
8. Battery: 5 kinds of batteries are available: no. 5 nickel metal hydride or alkaline battery, Panasonic SD series lithium battery, SONY lithium battery FH series FM series and P series three models.
Directions for use
1. 5 batteries, please according to sign (+) (-), put 5 batteries in the battery compartment, and the battery cover on the card, installing a lithium battery, battery has a socket side - first on the battery holder on the insert or pin, again a little bit hard to push press, make the battery card in the battery compartments, panasonic battery installed, must be combined with panasonic battery interface, can use.
2. Insert the hot boot of the LED camera lamp into the hot boot of the camera equipment and tighten the hot boot knob to fix the LED camera lamp on the equipment.
3. Turn the switch knob to turn on the LDE camera lamp, and turn off the power supply when the brightness is adjusted as required to stop using.
Matters needing attention
1. Please turn off the power when you stop using, so as not to consume the power of the battery or affect the life of LDE due to long time of emitting light and heating
2. If no. 5 dry battery is used in the power supply, remove it when not in use to avoid long time standing and battery leakage corrosion circuit.
3. When the LED camera light is on, do not look directly at the bulb
4. When installing the battery, please do not exert too much force to avoid damaging the battery compartment and inserting the needle.